Duet Laser Filament Motion Sensor
AUD64.95 Inc GST
This is a daughterboard specifically designed for the Duet 2 Wifi, Duet 2 Ethernet and Duet 2 Maestro that allows two PT100 temperature sensors to be attached. These PT100 sensors can be either two or 4 wire, there are jumpers on the latest version of the board for easily switching between two and 4 wire mode.
Available on backorder
Make 4 fortnightly payments of AUD16.24 with More info
Laser Filament Monitor
The Duet3D Laser Filament Monitor uses a IR laser optical motion detector to detect filament movement. The detected movement is transmitted to the Duet 2 Wifi, Ethernet or Maestro which uses the indicated movement to determine if the filament has run out, jammed or been ground away in the extruder. It is available for 1.75mm diameter filament only.
T The 3D-printed enclosure and M3 mounting bolts are not included. Please see the documentation for more information: Documentation for the Duet3D Laser Filament Monitor.
Note: The Laser Filament Monitor is sensitive to the filament type used: it has proved less senstive to PETG of certain types. Please read the documentation for more details.
Warning: The Laser Filament Monitor is a Class 1 Laser device: Under normal conditions, the laser beam is always below the IEC/EN 60825-1:2014 maximum permitted output level of 716uW according to the manufacturer of the optical sensor; nevertheless we advise against looking into the beam when the filament monitor is powered. You should most definitely not look at the sensor through magnification when it is operating. The laser beam is invisible infra red, therefore your eye blink reflex will not protect you!
|Dimensions||5 × 5 × 5 cm|