Selected:

Pin 27 Board for Bltouch suit Creality cr-10 ender 3

$8.95 Inc GST

Pin 27 Board for Bltouch suit Creality cr-10 ender 3

$8.95 Inc GST

PRODUCT DESCRIPTION

Description:

Works with CR-10, CR-10 mini, CR-10 S4 and CR-10 S5 aswell as CR-10S variants, and Ender 3 series.

Pin 27 board makes the installation of a Filament Sensor or a BLTouch fast and easy. Normally to install either of those items you would need to cut a wire from the Ribbon Cable and also get GND and 5v from somewhere else in the CR-10 stock S-Melzi Board.

Only 2 left in stock (can be backordered)

SKU: 707338963358-1 Categories: , Tags: , ,

Description

PRODUCT DESCRIPTION

Description:

Works with CR-10, CR-10 mini, CR-10 S4 and CR-10 S5 aswell as CR-10S variants, and Ender 3 series.

Pin 27 board makes the installation of a Filament Sensor or a BLTouch fast and easy. Normally to install either of those items you would need to cut a wire from the Ribbon Cable and also get GND and 5v from somewhere else in the CR-10 stock S-Melzi Board.

With the Pin 27 Board all you need to do is 5 easy steps (this assumes you have the control box open and a Bootloader already flashed):

Disconnect the Ribbon Cable from the EXT1 header Board

Connect the Ribbon Cable to the Pin 27 Header Board

Connect the Filament Sensor or BLTouch 3 pin wire to the JST XH connector on the Pin 27 Board (Make sure your wires connect to the right pins. Pinout from top to bottom: 5v, GND, Signal, the Board also has the labels n-ext to the JST XH connector)  Be careful here as if you use a straight through connector it swapped the connections so i had to swap 5v and ground as shown in one of the images.

Connect the Pin 27 Board to the EXT1 header in the S-Melzi Board

Flash the Firmware with BLTouch or Filament Sensor enabled, that is it.

You must have a Bootloader flashed to your CR-10 Board in order to use this. Support for that is not provided.

Brand

Creality

Additional information

Weight 25 kg
Close Menu
×
×

Cart